Thinking of upgrading the seats in the old TS Magna to a nice set of third gen ones.
Is this a remove and replace job or is some tinkering involved?
If there is some tinkering involved does anyone know what mods need to be made?

http://www.aussiemagna.com/forums/showthread.php?t=49197&highlight=seats

To answer the question, as i have done this, yes, it all fits (except door trims) although the base of the rear seat will need a couple of people to put some pressure so it lines up to screw it in.

Thanks guys.
Sorry, I didn't see the other thread when I was looking.
This is a big help, I just need to find a volunteer to help with the install????

Fronts are direct bolt in, you can even get the electric drivers seat in all its glory ;)

Rear, the back section needs some foam removed to reveal the metal bars which line up with the second gen mounts, bit of a fiddle but solid once in.
And the base of the rear you can either make up some brackets/drill and self tapper/zip tie it down, though I don't recommend that last one haha

Only thing is the base of the rear sits a little funny so there's a small gap, but it's so negligible only you would know that it wasn't right.