Hi guys

am having an unusual problem of replacing my low beam headlight globes in my KH Verada.

Having all sorts of problems lining up the globe, is there a trick to this.

Strav

Kinda......

Its a pain, what side? if its drivers side remove the washer bottle to give yourself more room. Firstly you removing the twist shroud then the rubber grommet. The clip then comes off, but with putting the globe in it can be a royal pain in the ass, there is no real trick just persistence.

Royal pain in the ass, took the words right out of my mouth lol.

Thanks, thought I was going stupid

There is a proper way it lines up, but you need to be able to see it properly, but normally with a quick globe swap your just trying to do it blind.

Just one other question, does the connector pull apart i two seperate pieces?

how does it line up?

the large nib on the bulb suppose to line up with the channel in headlight I assume?

IIRC, the electrical connector comes out then there might be a black globe holder in there to. The globe sits in the holder and then goes in, yes nib into the channel.

Not too sure about the KH but mine had globe holders.

same here, i have globe holders

Thank you very much for your help