hi guys Newbie here but not to Mitsis and forums.
I am searching with no avail is there anyone that's dne a pinout for the 3.5l diamate ecu?
basically im trying to match it up to another mitsi loom and theyr very similar but im missing a few wires and without good info(pinouts) id rather wait to do it right.

so basically im looking for the Mitsbishi 2003 VR-x Pinout.
I have a 4wd trans and a vr-x motor and loom,ecu,etc

please fogive me if thid I in the wrong place or for my terrible typing on my laptop(ipad user)

thanx in advance

Try searching for the factory manual on this site.

When I send you back your bellhousing I should be able to throw in a spare loom as well for you, can also print out the page from the manual or even perhaps will just pop the factory manual onto a flash drive and send that over as well if you want