Hi all

Are there any tips you can give regarding removal of all flocked pillar trims. I want to transfer all of these from my KH to my TJ VRX

I don't want to damage them of course so hoping i can get some guidance before i start

Thanks

Bump to the top. Any tips out there? Hoping for a bit of advice before i get started

no tips really....front a pillars ...pull from top ,may be tight....two clips .then ,once it is out at the top ...pull back slightly and pull UP TOWARDS ROOF ..as the bottom slides into a clip
b pillars...um...probably need to remove seats to access the lower black seat belt cover ,take door mouldings off ...trim is held in by clips

then lever up the cover on the upper seat belt to expose the nut ..undo ...now the trim will be accessible to take off

rear pillars..

remove back seat..top and bottom..

undo bottom bolt of seat belt....

trim....pull from bottom ..there are clips arouund the edges...once it is clear you need to push out the bit of trim where the seat belt goes through and then thread it and the seat belt through the hole...trim stays with the belt

while you are at taking all the seats out ,you may as well take ALL your door trims off as well ,as these need to come off to replace the outer handles

so ,,basically ,you will have to gut the interior of your car and the doors...lol