Hey guys, just bought some 380 washer jets and was wondering if anyone has any pics of the jets after filing.
Also where do you run the washer lines, I know I have to pry them apart and glue them back at a 90 degree angle, but I'd like to see some pics of someones setup if possible.

Cheers

you dont have to take the jets apart,this is optional if you want some more flow as you are removing a check valve. mine are stock and spray perfect.

i filed off the tabs and part of the body to fit.you could also widen the bonnet instead to fit the nozzles.

oh ok, how did you find the hoses, as the first set I had I screwed up the filing and they were too loose, my impatience got the better of me.
I find the hoses will kink when I put the jets in.

You need to get more hose and loop it back through the bonnet frame to stop the kinking.

Cheers Maggie.

Where exactly do you run the hose? I bought myself a set and know I need to file down the tabs.

I'll take a pic of where I ran mine and post it when I can.

I filled out the underside of my bonnet to prevent them from kinking. I also filled the washer jet itself more-so than the top side of the bonnet.

I thought my washer pump was broken, it turned out that the kinking was that bad not a drop of water was passing through the jets at all.

All fixed thanks to a file, but I admit it doesn't look factory. But meh, at least it sprays very very well now

Is it correct these spray in a mist as opposed to the spray in streams type?

Is it correct these spray in a mist as opposed to the spray in streams type?

Yes correct. A very large mist at that