Gill
26-04-2015, 10:16 AM
My 380 has become difficult to start. The key needs to be pushed into the ignition really hard.
I took off the plastic covers and noticed that the wiring assembly on the rear of the ignition lock was kind of loose. The assembly seems to be held onto the back of the ignition switch assembly with only one screw, so there is a fair bit of movement. This seems to be the cause of the problem.
I have put on a couple of cable ties for now. Once again my 380 starts without delay as a 380 should.
Has anyone else struck this problem? Do I have to buy a new ignition module?
I took off the plastic covers and noticed that the wiring assembly on the rear of the ignition lock was kind of loose. The assembly seems to be held onto the back of the ignition switch assembly with only one screw, so there is a fair bit of movement. This seems to be the cause of the problem.
I have put on a couple of cable ties for now. Once again my 380 starts without delay as a 380 should.
Has anyone else struck this problem? Do I have to buy a new ignition module?