Gday guys,

I am planning on doing some upgrades to my TH advance including climate control.
I know a lot has been written about this subject on this forum but was hoping to clarify if the wiring mash up i planning on using will play nice with each other.

I have a donor Kj series II, and will be fitting all the internal looms of the kj from the dash through to the rear of the car to the th. This will leave the looms under the bonnet as standard.
I have also sourced an upper dash loom, black out cluster and trip computer from a KH that would be used instead of the KJ upper loom.

Does anyone know if this wiring combo will work?

No.

You will also have to change the harnesses in the engine bay that isn't the direct engine harness. Fuse box, included and add the climate sensor. Also, make sure you add the different resistor to the AC and the small yellow wire for the condenser sensor uses a different plug and length.

Mike