I need to replace the bearing/entire clutch system on my air con compressor on my TF as the bearing is buggered or somethings scrapping as it makes a discusting noise at certain revs. Anyway, Ive tried removing the clutch of the AC compressor before, to get to the bearing, but it wouldnt budge, even with removing all the screws I could possibly see. Does any one know how to remove the AC clutch/pulley or know of any where that would tell me how to do it?

Thanks

Old post but incase anyone else needs this done.

Remove/loosen tensioner

Remove drive belt

Remove nut from centre of AC pulley (12mm or 14mm)

Remove small 8mm screws around the pulley (only Veradas I believe)

Remove the sleave that drives the belt with a pulley puller

Remove the clutch

Remove the circlip on the pulley

Remove the pulley with the puller.

Replace the pulley with a new or second hand one (not sure if the bearing can be pressed into these ones)