I know this is a bit of an audio question but my previous post in the audio section drew a blank
I have posted the same question again in the audio section hoping for a soultion just thought someone out there in 380 world might have some insight
I have a pioneer avic f20bt there is a wire called output speed sensor it senses the speed of the car and allows the unit to guesstimate position when GPS is lost eg. cross city tunnel I also runs the eco drive function which does fuel consumption etc
where in gods earth do i wire it up to
I'm thinking the output speed sensor on the box but which wire
I know its not really necessary but I need it hooked up its bugging me

I think from memory it's the pink wire....on the audio harness, my factory sat nav uses it when i go in tunnels etc.

I think from memory it's the pink wire....on the audio harness, my factory sat nav uses it when i go in tunnels etc.

Thanks Zilo
I'll have a look right now

I think from memory it's the pink wire....on the audio harness, my factory sat nav uses it when i go in tunnels etc.

well found it no dramas
I have to know, how did you know about, this its so obscure even Google was vague

Your a legend found it in the audio diagram for multi function centres I never looked that far connector 12 into plug c214 output speed sensor