as the title suggests i need some dimensions of the legnum front suspension if anyone here can help, long story short im trying to find a set of springs that will lower my Diamante 30M as the suspension set up looks very close, what im after is the diameter of the strut top bolts ( the three bolts that hold the suspension to the car frame) and the diameter of the coil top and botton

what i have is
diameter -138mm
top coil -147mm
bottom coil 87mm

if anyone is able to take a few measurements for me that would be greatly appreciated

http://i1377.photobucket.com/albums/ah56/hypermagna/20150810_201629_zps5ppfdazf.jpg (http://s1377.photobucket.com/user/hypermagna/media/20150810_201629_zps5ppfdazf.jpg.html)

http://i1377.photobucket.com/albums/ah56/hypermagna/20150810_201639_zps81v11tcw.jpg (http://s1377.photobucket.com/user/hypermagna/media/20150810_201639_zps81v11tcw.jpg.html)

:gtfo:Thanks for all the help legnum / galant owners its good to see that you know how to open your hoods and use a tape measure

:gtfo:Thanks for all the help legnum / galant owners its good to see that you know how to open your hoods and use a tape measure

how do you know there are any active in this forum? I spent some time in the parts catalogues and I can tell you nothing fitted to the legnum crosses to the Diamante in that setup except the nuts that hold the tower in place.

i would expect that the larger car would have a larger strut mount so the bolts probably won't line up either.

There's probably some international forum that may have some info but i can't think of one

This Diamante 30M, is it jap market and have a jap market VIN? I can try punching that into the program I have to find what's fitted number wise as it was built but not sure if i can find from that what you need. they don't give dimensions except maybe the odd bolt, seal, washer etc, not spring dimensions

TW2005 beat me to adding to that

Hypermagna, give me a call during the week and I can give you dimensions if you want, I have both a Diamante here as well as many legnum front struts.

I did look into this with my Diamante and determined from memory that much of this can be made to fit with little to no hassles. I was wanting to do this to remove my auto suspension BUT then decided I would just get brand new parts over from Japan and keep it original, it will not handle like a modded magna but then again it does not have to as part of the charm about it is how it drives anyway, this is why I also replaced the original bypass muffler with another brand new one.