Hey guys have the sports edition seems to have its own way but usually removing the door trim there's the

Air con screw the door hand screw and the door pull screw ive removed all and the window switchers but the panel wont budge no matter how much force any ideas

Also I followed the DIY tutorial but it wont budge

When I removed mine for the first time I had to give it a bit but I had a load of spares so I wasn't to worried about damaging it, Came off fine and went back on fine even though I did get quite rough with it.

Bottom edge, both hands, fingers under, pull.
Work your way around.
When all loose, lift up parallel to the glass.

I've tried pulling with someone pushing the door ive tried pulling with my feet on the door it just wont budge and im not a weak guy :( only way i can think of is a crowbar its like theres 10 screws holding it in

Where in NSW are ya? Maybe the previous owner has glued it on? Should not take that much to remove it.

Aha Yass lol I've tried the driver's door and the front passenger door. Both the same maybe he glued it but then again the guy knew nothing about cars

bump?

bump?

Why bump? If the previous owner has done something strange, it is up to you to work out what is going on.

HINT: If the door trim is glued down, run a sharp knife along the joint.

Im used to facebook you bump to bring it to peoples attention etc and i shoved a screwdriver with cloth around it and managed to pop it out. Broke a few clips :/ but goes back on fine