Hey guys i'm planning on replacing the rear right eletric window glass in my Verada xi 2002, just wondering if any of you have any experience and can offer any tips?
I have taken off the side panel and exposed the mounting bolts theres two down the bottom of the glass panel..

take off the trim strip from the top of the door frame, from memory there is a small screw on either end of the trim, pull back the rubber weather seals and you'll see them.
There is a couple of bump stops and 2 hook stops on the bottom of the glass, the hook stops need to come off but the round bump stops can stay.
Loosen off the mounting bolts that hold the glass to the window regulator. You may need to move the window up and down to access everything.
Make sure the window is right down when you take out the last bolt, otherwise it may fall off the regulator and drop into the door, possibly smashing but definitely scratching the window tint. ask me how i know....
Carefully remove the mounting bolts then lift the glass out of the top of the door. An assistant is very handy at this point.

Installation is reverse of that.
Once its in, wind the window all the way up with the bump stops and hook stops a little loose. use the bump stops to limit how high the window sits against the body and top weather seal, make sure the hook stops engage their little frames at the top of the door. once your happy with it, tighten it all down.