PDA

View Full Version : Engine Bay Layout.....



ezrider4u
16-01-2005, 10:27 PM
As I look through and check out different things on the Australian sites about our cars, I notice small differences in the way these vehicles are made. Case in point, in the attached photo of my engine you can see the throttle cable going around the plenum. However I look at the shots of your Magnas and Veradas and this cable is not position the same.

Do we have different throttle control systems in the US and Aus versions of this car or do you guys just find a way to remove/replace this eyesore :disgusted ?

http://www.cardomain.com/memberpage/468744/2

BOosted' BOoya
17-01-2005, 05:34 AM
As I look through and check out different things on the Australian sites about our cars, I notice small differences in the way these vehicles are made. Case in point, in the attached photo of my engine you can see the throttle cable going around the plenum. However I look at the shots of your Magnas and Veradas and this cable is not position the same.

Do we have different throttle control systems in the US and Aus versions of this car or do you guys just find a way to remove/replace this eyesore :disgusted ?

http://www.cardomain.com/memberpage/468744/2


perhaps the cable is different because you drive on the wrong side of the road? lol - id say thats why the cable is in a different position... your steering and throttle is on the oppsite side that ours is on!