First of many posts, so be kind :)

I've accuired a 1992 TR Magna...

I've got a 'top-of-my-head' quote for the following mods:

2.5inch exhaust - $240ish

Pod filter - $60ish

Extractors - $400-600

How does that make you react... too low that its got to be dodgy? Too high?

Comments please, I dont even know what an extractor did until I walked into the store :P

HI Welcome!

That's a good start for your mods....

Keep it up and once again, welcome to the community...

CHEERS

hey welcome

ok heres a few things to consider with the mods your getting

1. is the 2.5" piping mandrel bent? if not, then go get a quote for mandrel bent. press bent isnt good

2. is the pod gonna work properly with your mas sensor? if its a generic pod then no. Generic pods are made to twirl air however mas sensors dont like this and will get inaccurate readings because the twirling air bypasses the sensor.. meaning you will run lean. the kind of pod you want is an oval shaped one. Not sure if anyone other than k&n makes these. Probably better for you to go for a k&n panel filter as the only difference between the pod and panel is that panels are a lot cheaper but pods make noise... performance wise there is no difference

dont think theres any problems with the extractors so long as they fit.