hi every 1

i got my hands on a cheap TR'93 for $300 its very strait with a shabby intierior unfortunetly it didnt stand up to the shifty vacc test n snapped a timeing belt less then 20km from where i bought it from....well i picked up a tp motor for $200 and the only reason i did was because i was reashored it would convert over with the only problem being the knock sensor....Has any 1 ever converted 1 over and if so did u have any major problems doing it??

shifty......

thats bad luck man, good thing u didnt pay any more than 300..

as far as i know, the engine is exactly the same to mount in.

They fit, however I can't help with the knock sensor problem. The other problem is it is illegal, in Victoria to fit a motor to a car that is older than the car.

A TP engine should bolt into a TR but there are a few differences
all TP and TR carby were the same compression,
TR EFI engine had higher compression
TR EFI is sequential, TP isn't
TR have shorter valve stems, roller rockers and cam to suit
TR have different engine mount brackets

If you do fit the TP engine then change over the top end to keep the proper roller rocker head and injection, also replace all the welch plugs and rear main while you still have the block out,
If vic roads will accept an earlier series engine number in a TR and u don't care if it's a low compression slug then go for the TP engine.
Good 2nd hand TR/TS EFI 4cyls are worth about $500 from the wreckers with 3-6 mths warranty.

Good 2nd hand TR/TS EFI 4cyls are worth about $500 from the wreckers with 3-6 mths warranty.
Mine shat the big end bearings 2 days out of warranty. After thrice killing heads, and gaskets.

thanks 4 the replys every 1.....

now i would use the top end but 2 of the valves have hit the top of the pistons ,i can use the rockers n what not but can i use them if i havnt got the valves???????


shifty

hey y we r on the subject any 1 want it? ill sell it $625 wait $725 so you can knock me down to $625 k.......0415712001-shane..im in melb

shane-shifty

i have heard that the valve stem length is slightly different n roller and non roller rocker heads, ring an engine machine shop to confirm this.