I was looking at the front struts on my TR today, which seem to me to be very short. yet the front sits up about 3" from the wheel. now givin that your not supost to lower more than 1/3 of the total travel, and that the spring looks about 8" long, it still wouldnt be low enougth! has any one else had problems lowering gen 2? i would love to have all the wheels dipping inside the arches. I just looks so tough.

On the 3RD Gen Verada's It is the same problem: Mine is Lowered 80MM from factory But my bump stops are cut more them half the ride is OK" but not the comfort you would expect, from a Verada As for the wheel arche's
wheels dropping inside the arche I think it can be done ,The back of my car is droped 80MM and the front is droped 85MM but I must worn you no more speed bumps ECT as my car hits the bump hard going around 2-5 KMS per hour.

mines dumped 2.5inches looks ****ing good, rear even with arch and front i got 2 cm which is tiny....wouldn't go any more personally, its low as but to go further would cause big hassles and reach the limit of the stock springs...

Mine's dropped 2 inches, and no problems.