well, after much searching it is getting very hard to figure out how to wire up the parabolic headlights, i've got the diagram for the TH normal and KJ para's, if anyone wants to take a look feel free!!
http://home.iprimus.com.au/dchamberlain/th-normal.gif
http://home.iprimus.com.au/dchamberlain/kj.gif

At the connector for the low beam headlight there will be 3 wires cut the red one and connect it to the body (negative) for both headlights

2 of the 3 wires have a colour code stripe on them and go into the connector very close together, the red (all red) wire goes in to the connector by itself.

When I say cut the red wire and connect it to the body I mean the connector end of the cut wire goes to the body, the other part of the cut wire which runs back into the loom needs to be taped up.

You may notice in the wiring diagram the standard lights have high/low in one light and high in the other where as the parabolics have low in one light and high in the other.
EDIT Be Careful you don't get misled.
*Caution* The diagrams can mislead with the conversion as you change from a 3 pin bulb to a 2 pin bulb which use their pins differently, your high beam pins in a Stand become the low beam in a Para.

hope this helps

This thread might help, hopefully all the pics are still linked properly
http://www.aussiemagna.com/forums/showthread.php?t=4866

guys with paras,

are you using HB3 and HB4 bulbs, or are you using H7 and H1's????

well done PhilsTH! been so long trying to figure out this is actually done (and have a decent pic showing how-to)

now i just gotta remember which way the plug the high beam in :confused: stupid thing can fit both ways

guys with paras,

are you using HB3 and HB4 bulbs, or are you using H7 and H1's????

I'm using the H7 55W and H1 100W night vision bulbs. :)

you shoud put this in AMC wiki :)