say we have at the moment mags that are 4x114.3 and have a car that is 4x100
is it possible to get the mags re-drilled to put another 4 holes in to accomodate the smaller stud pattern? if it is possible as i am pretty sure it is where abouts in perth can you get it done or at least talk to someone who does it
???

say we have at the moment mags that are 4x114.3 and have a car that is 4x100
is it possible to get the mags re-drilled to put another 4 holes in to accomodate the smaller stud pattern? if it is possible as i am pretty sure it is where abouts in perth can you get it done or at least talk to someone who does it
???
I don't think that is legal. Not done properly will weaken the wheels (don't want your wheels
falling off at 100km/hr). As I mentioned previously, its not just the PCD that has to match. There
is the offset and the spigot diameter (the hub diameter has to match exactly as that is the load
bearer and fitting spacer rings is also illegal).