PDA

View Full Version : Conrod and crankshaft from 3.5L


Fuzzlet
12-09-2005, 10:42 AM
Well ive found on ebay the crankshaft pistons and conrods from the 3.5. Just a random idea, does anyone know any differences in stroke for the 6g72 and the 6g74?

http://cgi.ebay.com.au/MITSUBISHI-MAGNA-3-5L-PISTONS-RINGS-CONRODS-BEARINGS_W0QQitemZ4574845336QQcategoryZ10400QQrdZ1 QQcmdZViewItem

http://cgi.ebay.com.au/MITSUBISHI-MAGNA-3-5L-V6-CRANKSHAFT-DIRECT-FROM-FACTORY_W0QQitemZ4574846894QQcategoryZ10400QQrdZ1Q QcmdZViewItem
Jasons VRX
12-09-2005, 10:47 AM
Well ive found on ebay the crankshaft pistons and conrods from the 3.5. Just a random idea, does anyone know any differences in stroke for the 6g72 and the 6g74?

http://cgi.ebay.com.au/MITSUBISHI-MAGNA-3-5L-PISTONS-RINGS-CONRODS-BEARINGS_W0QQitemZ4574845336QQcategoryZ10400QQrdZ1 QQcmdZViewItem

http://cgi.ebay.com.au/MITSUBISHI-MAGNA-3-5L-V6-CRANKSHAFT-DIRECT-FROM-FACTORY_W0QQitemZ4574846894QQcategoryZ10400QQrdZ1Q QcmdZViewItem

The 3.0Litre has a stroke of 76mm and the 3.5Litre has a stroke of 85.8mm
BlueJ
15-09-2005, 04:46 PM
Apparently the 6G74 has an 18mm taller deck than the 6G72.

So if you used a 6G74 crank in a 6G72 block you would need to use shorter rods.

Anyone stroked a 3.0?
Fuzzlet
15-09-2005, 05:10 PM
Anyone stroked a 3.0?
That was my thinking, but Im going for something else right now engine wise :D
REV937
15-09-2005, 05:35 PM
That was my thinking, but Im going for something else right now engine wise :D
:) Which is ????
Fuzzlet
15-09-2005, 05:47 PM
Well I am wanting to get personalised plates, something like PB 95 TS, but after engine swap, TT 95 TS would be more fitting.....Im looking at getting a twin turbo dohc 6g72, but depending on what insurance have to say, maybe just the non turbo dohc and work the hell out of it