Got some suspension mods happening before MM05. My car already has a Whiteline rear sway bar (the non adjustable one), and a front Anti-Lift Castor Kit on it - done at MRT. Its about to go back to them for the fitting of some standard 02 VRX springs, KYB sports shocks and a Whiteline front anti-roll bar. So in effect, apart from the uprated roll bars, it'll be like a VRX with an Anti-lift castor kit in it, hence the question. Should I bother with a camber pin at standard VRX ride height? Has anyone got this combination on their VRX?

Depends what you'd want to do.

I've got a VR-X ride height now and camber set at -1 degrees on both sides symmetrically using camber pins. You can actually see the wheels slanted now, but I havn't fully tested it out. Downside on street use is that the car will not go straight when you let the hands off the steering wheel due to the offset of the road. But on the strip and track I would say it would be rather different.

Depends what you'd want to do.

I've got a VR-X ride height now and camber set at -1 degrees on both sides symmetrically using camber pins. You can actually see the wheels slanted now, but I havn't fully tested it out. Downside on street use is that the car will not go straight when you let the hands off the steering wheel due to the offset of the road. But on the strip and track I would say it would be rather different.

Hmmmm... interesting. Has your car had a 4 wheel align to suit?

Hmmmm... interesting. Has your car had a 4 wheel align to suit?

Of course.

okay - good - thanks for the feedback.

hi all

does anyone know if the stock misti 3000GT front camber adjusting offset bolts in the struts will fit a manga series 3 . . ..

they look remarkably similar in design from the .pdf manuals piccies .. . . .

might be a very simple way of getting adjustable front camber using factory parts - if they fit!

regards

simon

hi all

does anyone know if the stock misti 3000GT front camber adjusting offset bolts in the struts will fit a manga series 3 . . ..

they look remarkably similar in design from the .pdf manuals piccies .. . . .

might be a very simple way of getting adjustable front camber using factory parts - if they fit!

regards

simon

Well the Whiteline camber bolt kit is like $80... and I doubt you'd get ANY part for a 3000GT for such bucks.

Sarras - if you havent already got a strut brace...... do it! you wont regret it!!

Sarras - if you havent already got a strut brace...... do it! you wont regret it!!

First thing I ever did to the car was fit one - cheers...