Right i posted this pic a few days ago:

http://i7.photobucket.com/albums/y281/Yariiice/a60817b6.jpg

which started a whole ' hot air, slow, inefficient death' type thang, but as i said then i was not finished. I have been busy and have completed my C.A.I ( SORRY FOR SHOCKING PICCYS
)

http://i7.photobucket.com/albums/y281/Yariiice/S2300014.jpg
http://i7.photobucket.com/albums/y281/Yariiice/S2300011.jpg

With the entry being here:

http://i7.photobucket.com/albums/y281/Yariiice/S2300013.jpg

The whole thing is 90mm pipe from entry to box and cost less than $20 to make, I have noticed a difference in fuel efficiency and a slight difference in acceleration at the high revs.

looks alot better dood, i wouldnt mind doing that to my car, seems cheap and easy.

It took 2 hours ( including paint drying time) and all of the parts are available from ze Bunningzki Varehouse, all you gotta do is cut the pipe, undo a wiring clip and move, remove the foglight mount and cut the placcy engine liner bit and the recessed bumper part. I'm a moron ( mummy said so :D ) and i managed it!

:badgrin: And what U have on TOP of the engine -Sprintex?? :bowrofl:

to each is own :badgrin:

Oi numnuts theres a whole nuther thread discussing the piece of junk ontop of the engine ( which has now gone as the i worked hard to make that factor has worn off ) This is about something different.....