hi if i have a dual coil sub would it be better for me to wire the sub in 2 channel or 1 channel??

JL w3 sub

thanks

Their is no simple answer to your question.

First of all, what kind of amp will you be running this sub with? mono block/ 2channel / 4 channel amp?

Second, what are the coils impedance? ( 2 or 4 ohm... maybe even 6 ohm )

Third, what are you after, SQ or SPL?

i have a JL W3 12" and its dual 4 ohm, which i wired parallel (i think) and bridged two channels (i think) on my 4 channel alpine amp

Trav

You should always wire DVC subs with both coils in parallel or series on the same channel, otherwise you may have issues with a slightly different signal/level reaching each coil.

thanks ppl

run the sub t 2 ohm load =]
make the amp work



i blew a 150amp fuse yesterday =[[[[[
$20 for a new one =[