Did a search only found info on a 2nd gen idle control

basically my idle is at 2000rpm since got the car back
its a TF for who ever didnt know and i wanna put the idle back to 1000rpm
dave explained this to me but was over the phone and i have forgotten
help please :D

Is this since you got your haltech put in?

Not sure if its any help, but to adjust base idle on a 3.0L you need to insert a jumper wire between terminals 1 and 4 on the diagonostic connector under the drivers side dash then simply adjust the screw at the top of the throttle body per below picture until its set as desired. Then remove jumper wire.

Sorry about the pic as I took the pic with my camera out of my haynes manual, but you get the idea :D

a jumper wire ?? so like a multi meter ?

a jumper wire ?? so like a multi meter ?
No, like a single wire.......to short the signal.....i.e. cut a small length of wire, stick it in terminal one and stick the other end in terminal four to short the two together.

Once shorted together, adjust RPM per previous picture. Once set to desired RPM remove jumper wire. Enjoy :D

aight sweeet can do that

will do in the morning :D

Is the high idle from a TB mod or a haltech tuning issue? Most idle dramas are from poor TB modifications esp when attempting to oversize.

i changed tb a while back now never had an issue..
since havin the haltec put in and removed now the aircon is also wired up differently so that it doesnt raise the revs it just drops them

Who installed and 'tuned' the Haltech for you? How much did it cost may I ask?

nah nah nah hatec has been taken out so its back to standard