Hi ppl!
First of all, i'd like to appreciate the great work done here. kudos!
I'v got a 92' TR SE and wanna replace the standard cassette player with my pioneer cd head unit. Can anybody tell me how to get the audio console off the dash.(and ne instructions on installing the head unit). And i'd also like to know how to remove the rear door card. Especially the window winder. Thanx :)

Getting to the HU is as simple as 6 screws :D

1st two are at the back of the centre console, on either side at the bottom of it. Then open the ashtray and pull it out, under that there are 2 more screws.

Take off the gearknob and then that section will pull off (you may have to unplug the ashtray light). Once that is off you will uncover 2 more screws in the next section of the console, take them out and there you have it. The centre section will now pull out and you get get to the head unit.

Door card: (front doors)

3 screws in the part that gets covered by the dash when the door is closed.
2 screws on the outer side of the door card (side nearest to the back door)
1 screw in the underside of the front of the armrest
1 screw behind the handle part of the armrest (will need to pop the cap open with a knife or flat screwdriver)
Pop the cap out of the door handle and there is a screw there
Pop the cap out of the back part of the armrest and there is another screw there.

Removing the winder can be as simple as sliding a rag behind the handle and working it back and forth until the clip comes out. I highly advise putting some plastic down or something so if the clip falls you can find it.

Then you pull the card at the bottom corner and all the way across to the other side to pop out the plugs that hold it in and pull it up by the armrest handle.

As for installing the CD player...no idea sorry lol

Cd Player is easy,

On The Head unit There will be four pairs of wires for the speakers,

(havent done a pioneer unit in about a month so double check the colours with the installation manua

There should four pairs of wires,
Grey and Grey+black
green and Green+black
etc

These are for the speakers, Check the manual for which one goes where,

There should be 4 other wires

Black - Ground Connect this to the chasis somewhere
Red - ingition wire conect this one to the acc wire on the car
Yellow - Battery Wire, Connect this to somewhere that has power even when the ignition is off
Blue - This is the remote wire, it is used to power on amps and stuff

Pretty Sure those are right for the head unit, i can get the colours of the wires in the car's harness for you tonight when i get home, Dont have them here and it has been about 12 months since i have worked on that part of mine :lol:

If you are going to replace the front speakers then dont use the factory wires and Make sure you solder the wires!, dont just tape them.

There you go! a complete guide in 2 replies :D

thx gys!
got the player workin finally![/img]

Holy shit! I thought you had pics of my car! That's the same one I have ;)

DEH-P4350, great unit!!