a friend who has a manual th is about to put power cable for his amps but cant find a gromet. can someone tell me or better yet take a pic of where the gromet is. it only has to fit 4 guage.

thanks in advance

http://www.aussiemagna.com/forums/showpost.php?p=344222&postcount=17

For autos it's here anyway. Second pic is looking from the drivers footwell, first pic from engine bay.

that would be the most difficult way to do it!!

theres a grommet on the passenger side strut tower, poke it thru there (cut a hole in the grommet)
it will then feed down into the wheel arch (jacking up that wheel helps a lot)
move the plastic out of the way, and theres a blank grommet that feeds into the passenger side foot well. (1 or 2 screws has that cover off)
and theres heaps of room to run power cable underneath the standard cover panels that run to the back seat

haha its easier than jacking up the wheel??? ;)

If you go through the centre grommet you can fit any wire through I just ran my 0 gauge through the centre tunnel

Asylum is on crac. Passenger side is very easy, have fit 4ga in there, cut a hole and feed it through, it will actually feed itself under the plastic ready to go ( well it has the 5 or 6 times I have done it :D )