hey guys i'm trying to install an oil pressure gauge but have been through a lot of trouble..

I got an aftermarket oil pressure sensor with the gauge which is Drift Neo series but it doen't fit on the magna block and have been to so many different places to find an addapter for it but no luck...

so my question is for those of you who have installed one how did you go about getting to fit on a magna??

many thanks

well there is to ways i know coz i came across this with my monty

1. there is a adapter plate that goes on you oli filter so you can put in oil temp and presh in i can buy those in nz from DRIVIN PERFORMANCE BUT THATS $$$$

2. this is what i did i went to a hydrlics place and bought a male addpater and constructed an extenshoin pipe to bring the new sender away from the mount what was in my way. i exteded it about 15cm and it gave me cleance to put the new sender on prity much you just bring the hole out of the block to where you want it and it cost me like 10 bucks to do it, if you want a pic of what i did pm me with you email and i will send it you

this adapter plate you are talking about i have seen on ebay was $40 + p/h just make sure if you buy one that it is the same as your standard oil filter.

thanks for that but where in melbourne can i get an adapter???

sorry mate, this is all my fault :bowrofl:

good luck in finding an adaptor :D

Give pirtek a try mate, thats where i got the adaptor for my oil pressure gauge from.

where abouts are they mate

thanks heaps