Hey Guys

Hey guys im building a custom box to house my custom car computer in my boot
however my car is on a short holiday at the moment, so i cant measure it for the box.

i need these measurments and please make it very accurate to the mm please.

attached is a photo so u get what i mean.

cheers in advance

http://i7.photobucket.com/albums/y285/Skando1/bootsetup.jpg

just wait till ur cars back! best bet mate othewise u will ahve problems

i'm pretty sure width is about 940mm??? sounds right for some reason, oh, but thats about half way up the wheel wells, i'm pretty sure its wider at the bottom. not sure about height to ski hole at all!

but yes, differences in tar sound deadening and panel gaps mean that not all cars will be exactly the same, sure only a few mm difference, but could be enough to stop things fitting.

Wait till it comes back.

I think assylum is right cause I made a 3cuft sub box for someone and the MDF came in 900mm long bits which just fit between the wheel arches! :D

yeah, its just under 900 between the wheel arches. Take it as 890 just in case. Height, is about 380mm. That goes over the ski port opening a little bit though. So I guess to the top of the ski port is 350ish. Why stop at the ski port top when u can go higher eh?

Oh, the most narrow point isn't at the floor either...its kinda like, 100mm upwards, in the middle of the bulge.