Hey guys,
I need to replace one of my studs on my TJII. Cant see this being too difficult, would anyone be able to tell me what i have to do?
Any special tools?
Also does it have to come from a TJII or any 2nd/3rd gen one fit as its the same thread?
Cheers.

:bump:
Really need to get this done by tomorrow for heathecote (or during). Would a stud from a TR fit a TJII (seen as they use the same thread anyway). Was thinking of going out to pick a part (DIY wreckers for interstaters - where my TR ended up :() and grabbing a wheel stud from my old car. A small part of my old car will still live on in the new one lol i dunno. Anyway any help would be appreciated.

As far as i knew the just bash out.. Be careful you dont damage the treads on the others while trying to get it out..:D

Dont know about the thread differances though..

yes... use a rubber mallet and hammer the ***** out... gently!! lol

Ok and how will it go back in?

Ok and how will it go back in?

do it up :P give it a tap into place then put a nut on it and pull it thru.