PDA

View Full Version : help needed for tp efi wiring



ute
10-04-2006, 06:35 PM
Hi all, i need a little help. I have just put a re-co motor in my TP efi 5 speed and all went well,
except for hooking up all the electrical wires. The wiring loom that runs along the fuel rail and to the injectors has a couple of wires coming out of it about halfway along,they are about 10 cm long and have a single and a double pin respectivly. I just cant figure out what they connect to. Gregorys is a bit lacking in info (i cannot read wiring diagrams ) .any advice would be appreaciated...:nuts: ute

Ol' Fart
10-04-2006, 06:37 PM
1 goes up underneath the manifold. gimme 5 and ill go through my manufacturers manual and wander out to my car.:D

ute
10-04-2006, 06:43 PM
ok ,thanks

Ol' Fart
10-04-2006, 06:52 PM
20954There should be 3 sets of wire coming out of that loom.

1 goes to the distributer

the 2 pin one should go up under the coolant housing that connects to the rubber pipe that runs to the heater

and the third single (2 pin in some cases) goes to the temp sender.

I put a picture of the loom in this post, sorry its on its side :redface: , if you want a copy gimme a yell and i'll email it to you. I'm always happy to scan diagrams etc as necessary.:D

Welcome to the site too, good to see another 1st gen owner, theres plenty of us and were always happy to help.:D

ute
10-04-2006, 07:53 PM
Thanks ol'fart that makes it a bit clearer for me, will have a look at it 2 morrow,(car is 30 kms away).ute:) (mildura)