PDA

View Full Version : K&N Part number



Colgate
12-04-2006, 07:17 PM
prolly been post a kazillion time so i apoligise ... i did do a search but could really find anything

http://cgi.ebay.com.au/Mitsubishi-Magna-K-N-Cold-Air-Intake_W0QQitemZ4627090763QQcategoryZ10400QQssPage NameZWDVWQQrdZ1QQcmdZViewItem

i know it's an ebay thread before the mods say or delete my post but i am chasing a part number for the pipe if anyone knows it or is it just a bit of pipe that has been made up

but it does have a K&N sticker on it unless they just put it there

onkytonk
12-04-2006, 08:16 PM
send a message to the seller, or print the picture and go to Autobarn or something.

Anon
12-04-2006, 08:21 PM
AFAIK there is no cold induction pipe for a TE/TH. Hell K&N don't event list our cars under their parts lists, its just coincidence that the 3000GT uses the same filter/MAF sensor.

It dead set does not look like it would fit. The piping must go straight down then out to the right a bit. This thing this doesn't look right.

DaJaJa
12-04-2006, 08:45 PM
yes thats the right kit for 3rd gen magnas....... rpw at the time sold them for roughly around $600... might be cheaper now.....

trevmanox
12-04-2006, 09:25 PM
i was bidding on this but lost out :rant: :rant: :rant:

dark_magician
12-04-2006, 10:05 PM
just make ur own and its cheaper......those coupler is bout 15$ bunnings 90mm diameter elbow pvc 5$ :think: then some hpc and k&n sticker then u hav k&n cai replica for under 50$:badgrin:

Twunka
12-04-2006, 10:09 PM
i have one of these on my TF they are a very good setup, the only problem is that i had to use cable ties to hold my pod filter high enough off the ground

Anon
14-04-2006, 04:36 PM
Has sum1 got these fitted?

I'm struggling to picture how those bends fit?

*EDIT* stand corrected...was thinking for some reason this lil bastard goes on the end stick air filter assembly *slaps head*

if your a retard and you know it clap your hands *clap clap*

_stonesour_
14-04-2006, 04:43 PM
Has sum1 got these fitted?

I'm struggling to picture how those bends fit?

*EDIT* stand corrected...was thinking for some reason this lil bastard goes on the end stick air filter assembly *slaps head*

if your a retard and you know it clap your hands *clap clap*

from the inlet right angle turn to the front of the car then right angle turn to straight down near the corner of the batery ;)