well my rims are on their way and now its suspension time....

i'm gonna get Kings superlows/lows combo cuz i can't afford coilovers yet and it will be a while be4 i can. i'm also gonna get a HD adj rear swaybar and a strut brace.

now with the superlow/low combo, will i need camber bolts???

i'm hoping to order 2nite so any replies 2day would be great guys.


Cheers

Tim

Well I put on camber and castor and found that you still get un even wear on the tyres. I think my setup was a little agressive though. I think that a lot of guys do without it but as he has your struts out and the bolts as I remember it arnt that expensive then perhaps you should do it.

I have king lows/superlows combo and dont have much of a problem with camber and uneven tyre wear. I dont think with the king spring lowering that a camber adjustment is necessary

well my rims are on their way and now its suspension time....

i'm gonna get Kings superlows/lows combo cuz i can't afford coilovers yet and it will be a while be4 i can. i'm also gonna get a HD adj rear swaybar and a strut brace.

now with the superlow/low combo, will i need camber bolts???

i'm hoping to order 2nite so any replies 2day would be great guys.


Cheers

Tim

I was on the whiteline forum the other week and the moderator I was chatting with suggested that to maximise the effectiveness of installing a Front strut brace, you really need to install the antilift castor kit. I noticed only a minor improvement after installing my strut brace. So the next improvement for me would be antilift castor kit over springs/shocks.

supposidly - the 3000gt model has front struts/brakes very similar to the AWD magna - and they have adjustable camber pins from the factory - can anyonbe say if these are readily availabel in Oz from Mitsi?????

Well are you talkinh about front or rear..??? There is no bolt for the rear there is only shims available.. There is a bolt set up for the front i think.. Dont know much about front, only rear..:D