Just about to go and buy some 220w pioner splits, but iv got no idea how
to change them, please dont tell me i have to pull the whole door skin off

any idea's?

i cant wait to hear 'em
oh yeah it's a 99 TH

thanks....

have to pull the whole trim off

it really isn't that hard 'TH Smoker', there have been posts previously about how to go about pulling the door trims off. if you have time, do a search and I bet you'll be able to find the posts...

it isn't difficult, if you were doing it your self, give yourself a good couple hours of time to do it, make sure you do it right the first time, i mean the Phase of the speakers, if you get them connected out of phase, you'll find that your sound will seem very distant or towards one side even though your Balance is centre. so i recommend testing it before you put your trims back on. oh and if you have elec windows, it's even easier to pull your trims off, as I had manual windows and it was an extra 5mins to get the tools and another can of 'Coke' before pulling the window widers off. haha....

oh, and while you're at it, if you have any issues with the glass guide rails scratching your tint or windows, now is a good time to give the fluffy guides a good blow or clean or examination or losen or tighten...

Overall, I think you'll be able to do it without much problem. Just make sure you give yourself enough time. Don't rush things, else you'll find that you'll have problems later on.

oh yeah, you may need to make your own speaker brackets if you got something that doesn't fit into the 6" stock speaker holes.

yeah i had a quick search could'nt really find anything, im sure ill be able to do it just have to take my time

hahaha as i went to pick them up today i blew my amp for my subs again so i just turned around and went home

so now i have to fix my amp again
probly better off just buying a new amp but dont have the money for that

:x damn them cheap amps

its harder in my opinion putting them back on!!!

Its 3 screws and the Window winder Clip which you apparently can get a tool for but i just ripped mine out...

just unclip it from the bottom till its loose and then lift..

??

Thats it?

Oh and im not sure if its just me but mine was wet inside the door....

and i kinda just went MEH and left it as it was