I've been searching around for threads on removing the door trims off a TJ with Power Windows but there was no result.

I've removed the screws in the air vent, door handle and door leaver.
I know these doors a suppose to be clipped on but I can't seem the get them to unclip.
There is also a little red light on the front doors as well do they come out before the trim or with the trim and you disconnect the wire?

Any info would be appreciated.

Cheers,

Nathan.

Just pulllllll!

From the side and the bottom it will pop out. It's simple to unplug the lights and switches.

Make sure you take the little shroud off from around the door handle as well when you unscrew it or you will crack it.

3 screws is all is in there, the rest it pops out.

yeah just abit of elbow grease and bobs your aunty

hmm, intersting to know - i need to do the same, I have water getting on the scuffpanel under the doors, on all of them....so i need to figure out where the water is actually getting in from........anyone else have this problem?

I know these doors a suppose to be clipped on but I can't seem the get them to unclip.

I ended up jimmying the door trim off using a screwdriver. Use it like a lever - I placed it between the trim and the actual door at the bottom of each door.



There is also a little red light on the front doors as well do they come out before the trim or with the trim and you disconnect the wire?

When the trim comes off, you'll see where the light connects to. Grab the light and twist it like 45/90 degrees, and it'll pop straight out of it's housing.

There's a simple plug with a clip on it for the power windows.