linkage : http://cgi.ebay.com.au/19-inch-magix-looking-wheel-WOW-RRP-2399-00_W0QQitemZ130007767700QQihZ003QQcategoryZ6782QQr dZ1QQcmdZViewItem

these are 19" by 8" rims that i think like rather nice and would go nicely with my nice new KR the ad says that the stud pattern is for magnas, but will it physically fit under with out too many problems?

thanks
---

Well for starters they aren't legal, but hey, when does that stop anyone? lol.
They will fit, but depending on the offset they may stick out of the guards, which is also illegal.

linkage : http://cgi.ebay.com.au/19-inch-magix-looking-wheel-WOW-RRP-2399-00_W0QQitemZ130007767700QQihZ003QQcategoryZ6782QQr dZ1QQcmdZViewItem

these are 19" by 8" rims that i think like rather nice and would go nicely with my nice new KR the ad says that the stud pattern is for magnas, but will it physically fit under with out too many problems?

thanks
---

has anyone fitted 19s to a 2nd gen yet??

i reckon they'll physically fit under tha guards. but i really dont no.. would look sick though

has anyone fitted 19s to a 2nd gen yet??

i reckon they'll physically fit under tha guards. but i really dont no.. would look sick though
Yeh someone on here has, cant remember who. Quite a few members have 18's which fill the guards perfectly, but theres probably room for an extra inch in there :P.

not overly concerned about legalities (well aware its completely illegel :P)

dont want them out of the guards is all really, just wondering about that, dont want chunks of rubber flying ever where when ever theres a bump

Yeh dude u should be fine, but it may stick out a little, but if your not worried about legal issues then go for it cuz imo they will look sick!!

side note - how hard, any details? on how hard it is to flare the guards so its slightly less illegal?

wont be that hard for panal beaters. should cost bout $50 per side to get the guard rolled out and flared a bit

wont be that hard for panal beaters. should cost bout $50 per side to get the guard rolled out and flared a bit

damn thats not bad at all, no any one around vics northern suberbs that will do it? (thats good?)

Got a different question. From the looks of these wheels, they are not multi-fit (from the looks of the stud patter), so how can they fit holden/ford and magna? From what i know, holden/ford/magna have a different stud pattern

Got a different question. From the looks of these wheels, they are not multi-fit (from the looks of the stud patter), so how can they fit holden/ford and magna? From what i know, holden/ford/magna have a different stud pattern


He would have stock.. So he'd send you a different set depending on what car you have

Cummins had 19s on his 2nd gen.. Alot of the Ds in the US have 19s as well.. so just clear it up with Cummins.. See how wide his were and what his offset was! I think 8" rims may be a touch wide.. but then again.. I may be wrong!

SuFz :rant:

damn thats not bad at all, no any one around vics northern suberbs that will do it? (thats good?)

factory direct wheels and tyres
Thomastown 45 Wood St 3074
(03) 9466 4155

got some 18's there for my getz and they rolled my gaurds, $50 a corner...

you can get a deal on wheels from a shop though just as good as on ebay... what are the tyres going to set u back.... plus fitting etc...