Hello all,
just a quick question;

"where would my map sensor (haltech) be installed, as i think i might do a nice (good looking) cai similar to the rpw ones..."

I think it might be just before the t/b...

Also will i need a retune of the computer as i'd be putting a pod on with a more direct route of air-flow. If i do i'd install nos too lol ****ing cars. Yes im serious.

Thanks;
peace out;
aj

Being a Manifold Absolute Pressure sensor, I'd put money on it being in your inlet manifold :)

Being a Manifold Absolute Pressure sensor, I'd put money on it being in your inlet manifold :)


thanks dude, yes that would make sense lol.

I do realise i mispelt sensor btw everyone.

Retune??

No, it shouldn't need a retune. Besides, if it was comprehensively tuned last time it should already know what to do with the extra air from the pod.

Definately get a new tune if you're going nitrous though lol

yeh you'll need a new map tune with the nitrous

yeh you'll need a new map tune with the nitrous

Do you run two separate maps?

Do you run two separate maps?

that is correct. got timing retarted to get better results from the gas