Sorry to do this but i have a few questions.

What does the remote turn on wire do?

if i wanted to put an amp in the boot, where would be the best place to run the RCA cables so they dont pick up much interferance?

where is the best place to ground everything that is in the boot?

Thank you for any help.

The remote turn on wire should be on your head unit and your amp, it turns on your amp when your head unit turns on.

To wire in to the boot, first you have to pull out the back seat... that is quite easy. At the front bottom of the base seat there should be some pull clips, pull them and lift the front of the seat up, and pull it out... it is that simple. Then you should see where the best spot to put it through...i ran my leads staight up the middle as there was no other leads there and my sub is centred in my boot.

The earth is any good bolt you can find near your amp.

i ran my 4awg power cable down the drivers side and my 3 rcas under the carpet down the centre (my remote wire runs down there 2).
for my earth i used one of the bolts for the seat belt buckles under the seat. i crimped a ring terminal onto it and cut the end out so it would fit on then i just put the bolt thru it and screwed it down (make sure u clean it all up first, u want nice bare metal).

have fun.


Tim

yep, keep power on one side and rca's on the other!!!my amp is in the passenger foot well so no interference for me!!