hey guys, just picker up an audison SRx.2s :D :D :D now i opened the box and ed gahd!!! theres more dials then a go damn neclear reactor! does any one have any expirience with these amps (audison in general) ill be running my focal 165 k2p's off of it so i need help in how to set up and tune it for a front stage, its got all sorts of filter (high, low, full..... which one for front stage?) and high/low pass filter (ie. high pass at x hertz, and low pass at y hertz...) options..... its a pretty hardcore piece of amp and i wasnt expecting that much technology so much help would be appreciated,
thanks heaps,
tom

ps. could any one with a caa account pls make a thread anc copy paste this in? they taken away my posting rights for some reason..... douche bags

Well well well, I had the exact same problem when I opened mine :bowrofl:

If you are only running your splits in stereo mode and nothing else, this is what you do ( sorry if I make you feel like an idiot but ill tell you everything and working left to right ):

*Plug your RCA cables in the Pre In. You wont be using the pre-out im guessing at this stage.

*Plug the remote in on the hole to the right of the group of 3 holes. The 1st 2 hole are for the remote bass controller.

*Ignor the remaining small inputs ( 2x lots of 4 holes ).

*Set your gain. It is rated in VRMS.

*Set your Q ( rated 0.7 -2 ) This only works in HP mode ( which you will be using ). It acutally has a diagram on the far right next to the Power inputs that show you what happen when you adjust the Q. Basically the higher the Q, the more the xover Hz will peak.

* Move the black slot up the top to set HP mode.

*Side the next black slot to the desired Xover point from 50-350Hz.

*Ignore the next black slider as that is for LP.

*The next 2 plugs that can go up or down only effect the Pre-out when in HP mode. E.G. if you have the 1st one up and the second one down, the pre out ( the signal ) to another amp if you wish to do so will be a mono full range signal. If you have them both up, the output signal would be a mono variable LP signal, i.e. perfect to run a sub if you dont have a sub control on your deck. I would just leave them both up.

*Plug you speakers into the 1st 2 pairs on inputs. 1st 2 inputs are left, 2nd 2 inputs are right. +ive and -ive are marked. Last pair are only used for a bridged output, i.e. Sub out.

*Lastly plug your 8ga minimum power and earth in. 8ga is usually enough because the amp only draws 35A which is great for 600WRMS x1.

Hope that helps. :D

cool thx man, so basically half the **** on this amp i dont need to touch? haha

Yeah pretty much. Set the HP filter, Adjust the Q and tweak the gain and thats about it :D

When in LP mode you have to use the rest :doubt:

Great amp though as you will find out!!