who makes them? pacemaker and gennie dont make them!

who makes them? pacemaker and gennie dont make them!

Been there and had no luck. Have to go custom. Speak to Dave from RPW.

this is going to get expensive :headbange

this is going to get expensive :headbange

Basically when I was in Perth with my KS v6xi, I had Dave from RPW do a lot of the mods
and tried to get some extractors done. Dave sent me to an exhaust shop and after a close
inspection, the exhaust guy said that it cannot be done easily as there is not enought
space between the engine and the firewall for a decent length of piping. Your best option is
to source the front piping from a 3rd gen sports as they at least have the y joiner joining
the two banks rather than a T joiner which is what I ended up doing.

someone said that i can get a set off a 6G72 24V and change the flange's over but i am highly doubting it.

I said that if RPW makes them for a DOHC 24v 6G72 then you can change the mounting flange or whatever that is called.

It will work and it can be done. I know what I'm talking about.

rpw used to make them i had them on my sohc. Just go custom you should be able to get them done for 800$ which is about what it'd cost to get them from rpw also they'd be better quality. Let whoever's making them for you know they have to take out the front left drive axle to make them too...


KB rpw dont really do any **** for the dohc...

That's why I said "if" ;)

Anyway, any decent exhaust shop will be able to make them for you.

Mine were made from scratch and they cost $900

i might ring rpw tomoz and go see my local exhaust shop see if i can get a quote.


the joys of modifying :sook: