pseudomorphous
04-02-2004, 02:49 PM
i asked the question in the second gen's forum but so far no response so ill chuck it up here to see if i get any responses.
i have a hairline fracture in my exhaust manifold and am looking at replacing it with extractors so i have several questing about this.
If i buy the extractors from the site can i put them on myself without a welder by using the bolts and gasket or do i need a welder?
Also what brand are the extractors from the site and are they reasonable or is there somewhere else where i could purchase them?
And do they fit onto the flexible join or do they extend all the way to the cat and can they connect to easily or is new piping needed?
Also do i need to replace the entire exhaust system or is the stock system suffecient to handle the extractors?
And lastly would it be worthwhile in purchasing the high flow cat or is the difference rather negligable.
i have a hairline fracture in my exhaust manifold and am looking at replacing it with extractors so i have several questing about this.
If i buy the extractors from the site can i put them on myself without a welder by using the bolts and gasket or do i need a welder?
Also what brand are the extractors from the site and are they reasonable or is there somewhere else where i could purchase them?
And do they fit onto the flexible join or do they extend all the way to the cat and can they connect to easily or is new piping needed?
Also do i need to replace the entire exhaust system or is the stock system suffecient to handle the extractors?
And lastly would it be worthwhile in purchasing the high flow cat or is the difference rather negligable.