Hey guys! havnt been on in a long time due to no internet hehe, i just got a full set of new fusion speakers for the magna but i cant for the life of me find a tutorial here on how to get the front door panel off to access the speakers in the front doors, i took out all the screws but not sure where to go from there lol, it doesnt seem to move and im worried about breaking something especially cause it has electric windows, does anyone know where the guide is for this?

Thanks heaps in advance!

oh and if there is anyone in the QLD central highlands area (Emerald) that knows how to install a head unit can you send me a PM, i would go to the local place that does it but after what they did last time i dont trust them lol.

im guessing you've taken out the 3 screws
then just grab it from the bottom corner and pull
the trims are clipped on

yeh like roberto sed, the front doors have screws in the handle surround, aircon vent, and in the armrest under a little square (the bit u pull on to shut the door from the inside). once u do this lift from the bottom and pull out and up. its important u pull up coz the top of the trim is hooked over the window sill. like with anything in our magnas therel be that sickening noise that sounds like uv broken something, but dnt worry its just the clips coming outta the holes lol. once all the clips have popped out make sur u unclip the power window loom before u pull the trim too far away from the door. Hope this helps

Ah sweet thanks guys :D yeah i wasnt sure if i would break anything by trying to just pull it off cause its on pretty tight lol will give it another go this arvo sometime. thanks again!

Have you taken the door handle surround off yet? That needs to come off too.
Also not sure if you are anywhere near the gold coast but i'm happy to help you install the headunit.

ah, yes thats what was stopping it :D the handle surround thanks! now i feel stupid lol, im about 300km west of rocky so unfortunately no ware near the coast, but thanks anywho! ill just follow the guides on here and try it myself, :think: oh and 1 other newb question lol how do i know which is positive and negative going to the speakers? (and on the speakers themselfs) as i said its my 1st ever install and i want to get it right the 1st time lol

Usually the wires with a stripe/line on them is negative. (i think?)

ah, yes thats what was stopping it the handle surround thanks! now i feel stupid lol, im about 300km west of rocky so unfortunately no ware near the coast, but thanks anywho! ill just follow the guides on here and try it myself, :think: oh and 1 other newb question lol how do i know which is positive and negative going to the speakers? (and on the speakers themselfs) as i said its my 1st ever install and i want to get it right the 1st time lol
It doesn't matter, just be consistant with all your wiring, pick either - or + for the stripey wire and follow that for all your speakers. Glad to hear you got door trim out ok :).

All done! sounds alot better then stock speakers! but now i have found a problem, when turning ignition from acc to on there is a clicking noise (from engine and same right after i turn the car off (after engine has been running) turnt it from on to acc the engine stops (naturally) but then there is a rapid clicking noise for about half a second... any ideas? could i have dont this by installing the speakers some how? had the battery connected and disconnected a few times from - terminal left the + terminal attatched.. please help, worried!