hello guys!

does any1 here have electronics crossover installed with their system? coz if you do, can you give me advice on how to go about installing 1. i have 1, its just that im not quite sure how to install it. there is only 1 rca output from the head unit, do i need to split it? i also have 2 amps, 1 for the front & rear speakers and the other is for the sub. need some advice!

tnx guys!!

im running a three way electronic crossover as well as a three way crossover on my headunit (compilcated front stage)

Currently I have mine setup like this:

Ambient tweeters High passed off headunit and amp
Main tweeters High passed off headunit
Midranges band passed with headunit and external crossover
Midbasses band passed with headunit and external crossover
Subs low passed with headunit

I needed the extra crossover to control the extra drivers.

But if you just want to run front splits (assuming you have a passive crossover?) or front coaxials? Then you wont need a crossover, just use a full range signal from your headunit and high pass it with your amp.

Likewise for the subs full range from your headunit and low pass it from your amp.

Can your amps high pass/ low pass your fronts and sub respectively?

.. tnx for that!! got mine working now. been working on it during the christmas break.

.. thnx again =)