today i went to mcdonald's and this is what happin's when a 4wd drive revere's into the rear quater panel of a magna wagon ..........

http://i152.photobucket.com/albums/s180/psycho_cordia/25022008002.jpg

http://i152.photobucket.com/albums/s180/psycho_cordia/25022008001.jpg

http://i152.photobucket.com/albums/s180/psycho_cordia/25022008.jpg


but the good news is here is the insurance quote for the repair to it that i got today


http://i152.photobucket.com/albums/s180/psycho_cordia/IMG.jpg

wow that sucks. that is a fair wake. he must of been going pritty fast. did you tell him to put some glasses on. some people. i dont know how they cant see cars sometimes. i drive my dads 4wd around and i dont drive into people (well not on purpose).

Mike

he said he's mirror fell down and couldn't see it ........... yet we yelled at him to stop

Let me guess. It was the exhaust that made contact ? It happened to my old car and had the exact same damage.

tow bar right out the back like 12inches

is that the end of the car or will the other party(4WD) Pay for that


know how it feels a ..4WD banged up caspers front end

insurance .......

Good, make sure you send him the biggest insurance qoute you can find. :P

thats the biggest i can find around ...........another place was ganna charge 500

just be careful the insurance company don't write the car off, coz the cost of that you can replace the car. been down that rd many times.

hope your not 3rd party.

if they do that i am ganna see if i can buy it back and then i try to find a sedan or another wagon a do a transfer of good part's

if u can keep the repair below redbook value, then they fix it, if its above, they wont.

thats nrma and gio.

if you want to do the the labour yourself and take out the inner plastic shell


A quote only too paint the under coat

and then when ready respray the car the colour you want


DIY

bump the dent out a bit

then body fill and sand

should come up ok and no holes in the metal

bog it up :D

No don't bang out a bit and fill, dont bog and fill, it is not a commodore :)

You will need to get access from inside or use a spot dent puller

Once out, you will need to shrink the hell out of it and then you will be able to get a near metal finish. I would say the $1k quote would be doing just that.

You do not want deep body filler, it will especially in a place like that eventually crack if someone leans too hard on the panel.

well i don't know how they are ganna do it but all i know is the $1200 quote seems good as i went to the repair shop and seen some of there work i don't know how they do as long as it look's good when finished .......

today i went to mcdonald's and this is what happin's when a 4wd drive revere's into the rear quater panel of a magna wagon ..........


you went to the wrong place for a quote ...think outside the square

go to a camper trailer business and have them fit

a pull out gas cooker , fridge and bar

a roll out roof canopy in case it rains

for cruzez and picnics

ps dont worry about the fuel tank ......she'll be right mate

lol buff u make me laugh heheheheheheehehe ....

Beaver Panel Trim $7.50 ... bargain :P ...... I never knew that Toxic waste removal had its own part number! lol

Beaver Panel Trim $7.50 ... bargain :P ...... I never knew that Toxic waste removal had its own part number! lol

EPA guidelines are very strict in relation to the removal of dust, thinners, left over paint, contaminated rags, paper etc.

Generally a workshop will have a standard charge on a per panel basis to cover these costs.