I have a 98 TF 3 litre V6 auto. Does anyone know how to check the ECU for diagnostic codes, as in faults with sensors. Even just a link to a tech article would be good.

Thanks.

Is there anything in the manual you got with your vehicle?

Perhaps purchase a gregory's service / workshop manual and see if that has what you are after else put your car in for a service at mitsu and i'm sure they'll let you know if there are any dramas.

Try this, it works.If everything is ok it will blink continually or blink the code.Thats how i found my code 21

http://www.ftowa.com/html/workshop/workshopart07.html

Try this, it works.If everything is ok it will blink continually or blink the code.Thats how i found my code 21

http://www.ftowa.com/html/workshop/workshopart07.html

Have these FTO ECU codes been confirmed/verified to be the same as those for all Magnas?

This is out of the TH workshop manual, fairly close

http://home.austarnet.com.au/egelstaff/Image17.jpg

Thanks for your help so far, but does anyone know the code for a busted oxygen sensor? :?

It would help if you posted the code that you got from the ECU etc.,
I have had a look and there may not be a code so have attached a item out of the book.You have to attach a multi meter and check the voltage to see if they are up to spec.
http://home.austarnet.com.au/egelstaff/image18.1.jpg

Thanks for your help so far, but does anyone know the code for a busted oxygen sensor? :?


NO! But I have just had one replaced. Under warranty thankfully.

Cost of new sensor supplied by Mitsubishi should I have been required to pay ........... $325!!!

Pray it's something else. PRAY!