PDA

View Full Version : How to read trans fluid level?



oldmagna
27-03-2004, 09:55 PM
My transmission fluid (2.6 auto) was VERY low, basically empty, and I added some fluid. Someone I know told me they can take up to 4 litres, but I only put in less than 1 litre, and my hard to read dip stick says it's overfilled.
How much should it take?

pseudomorphous
28-03-2004, 06:03 PM
probably best to drain it and start from scratch. And yeah they are supposed to take 4litres of tranny fluid.

Matt
28-03-2004, 08:05 PM
i dunno about the auto box, but on the manual there is a Drain Plug, and a Level plug...basically u put the car on a level surface and put enough oil so that when u take the level plug out it is right there.......about 2 litres i tihnk correct me if im wrong?

oldmagna
29-03-2004, 08:28 AM
I better add some more fluid, thanx alot guys.

Matt
29-03-2004, 09:24 AM
Ok i just checked the Gregory's workshop manual and it says that the Auto Gearbox capacties are:

Carurettor model = 6.1litres
EFI model = 7.5litres

Hope this helps

MAGWGN
30-03-2004, 09:45 PM
DO NOT ADD MORE FLUID!!!! over filling an auto transmission is one of the worst things you can do. unless you have a severe leak you will not need hardly any to top it up. 1 litre was probably already to much. you probably did it wrong. run your car until its hot. park it on a flat surface and turn it off. check the fluid. if its low, add a little more through the dipstick hole. turn your car back on and run it through the gears. turn it off and check it again. to much fluid=BIG BAD!!!!

oldmagna
13-04-2004, 02:35 AM
DO NOT ADD MORE FLUID!!!! over filling an auto transmission is one of the worst things you can do. to much fluid=BIG BAD!!!!
Too late, I read the manual and it said not to overfill it, but I've put in about 3 1/2L, I was scared this was too much but it seems to be running well.
What can go wrong if it's overfilled?