Hey guys, so after all the help on the last thread i did some research and found out i can install just the keyless part into my car, seeing as i already have central in my car.
I went on ebay and found this, does anybody know if this will fit and how to install or has a guide?
Thanks

http://i636.photobucket.com/albums/uu81/acsata/c8_1.jpg

http://i636.photobucket.com/albums/uu81/acsata/f5_1.jpg

Lol thats the exact same kit i was going to buy for my car before i decided to let someone else do it for, the wires plug in near the fuse box under your feet somewhere and so does the control box, thats about all i know.

ahh thanks, do u know if ill need to run the wires in the doors?

ahh thanks, do u know if ill need to run the wires in the doors?
I don't think so, i think it just plugs into the master lock thing that triggers all the doors at once, it only took my auto elec like an hour to install so im guessing not.

ahh ok, how much did he do it for? for a benchmark price.

i can find a wiring diagram if you like, have the haynes manual? its in the back.

also no need to post 2 threads.

You will need to connect red to contant 12v at the ignition. the wire is red on the back side of the termonal block and black on the front side located at the bottom of the steering shroud pic below. Just remove plastic from wire do not cut and then connect wire and tape up, solder if you have one.

Black on unit should be earth, mount on any steel.

Find lock and unlock wires on unit should be two in total.

Connect to cars factory central locking module located in drivers foot well bottom right under fuse box.
Power lock Red/Blue silver dots.
Power Unlock Red/Black silver dots.

The wires on the new module to use: once power is on try the alarm wires first as these should work.temp connect one and try,if no go try other car terminal. Should work so now hook up second wire and if working connect properly.

If not working repeat process with two wires for a supplied locking unit.

NOTE: There is a chance of blowing a fuse if wrong wire connected but very remote.
I take no responsibility for this guide. (Only not sure about the modules correct lock/ unlock wires others are spot on.)

Thats it you know have remote central locking.

All other wires can be removed, use a watch flat head screw driver to remove unwanted wires from new loom be inserting it from the back of the plug and pushing down on internal wire clip.

If you get it back to front not a problem just reverse wires.

The pics are just for general location, please ignore the main wires there as they are for my alarm remote start.

Hope this helps you out.

How much was the set on ebay? Keep us updated how u go installing it