Just wondering if anyone has completed a cruise control conversion on a TE-TF magna.

I have all the parts just wanted to know if you have to unpick the loom or is it easier to change tha whole loom over.

Thanks

did it recently on my tj
only had to run 3 wires to the engine bay the rest were available in the centre console below the ashtray, you'll need the switches, clock/slipring, CCECU and short loom, vac pump, stop switch, and cruise control throttle housing.

im an autosparkie by trade so it as a breeze for me, but if you download the mitsi workshop manual then you shouldnt go too far astray

Thanks Ash were can i download the manual from so i can pull this thing apart

Workshop manuals are here (http://www.aussiemagna.com/forums/showthread.php?t=56815).

Mate, have done several of these

Am more than happy to do this for you, is a dash out job to do it right, the engine bay harness does nto need to be touched, you are best off chaning the dash and under dash harness to do this properly as you will need to tap into your ecu as well as other harness with a crap load of wires

http://www.aussiemagna.com/forums/showthread.php?t=59677

only 16 wires... hardly a crap load