Hey,

Just wondering when changing the background of a cluster, when you go to put the needles back on how are you meant to get them in the right place? Any Tips?

take a photo before hand.

put the cluster back in.
Start the car until it warms fully up, Onc the temp is at normal temp put the temp needle back on where it normally sits when warm,
Fuel gauge same wy if you know how much fuel is there ( Best take a pic b4 pulling apart)
rev needle place back onwhile engine is idleing.
Now with another car in a car park drive and relay back the speed and gently put the speedo needle back on all complete.

push all needles back on then put the cluster back together again.

put the cluster back in.
Start the car until it warms fully up, Onc the temp is at normal temp put the temp needle back on where it normally sits when warm,
Fuel gauge same wy if you know how much fuel is there ( Best take a pic b4 pulling apart)
rev needle place back onwhile engine is idleing.
Now with another car in a car park drive and relay back the speed and gently put the speedo needle back on all complete.

push all needles back on then put the cluster back together again.

Yup, followed this all good.