Ok i know were to put the front footwell LED's but were do I put the backseat footwell LED's? and is there any other place i can put them to light up the car, yes its ricey :P

For backseat, under the front seats (facing backwards)?

Other ideas: I'm planning on putting some under my 6x9 covers, think that'd look sick.

Cheers.

call me a noob or what ever but the 6x9's, they're the ones in the front doors right?

Nah dude, 6x9's are the ones basically above your boot, behind the rear seat, below your rear window..

The ones in the front doors are most commonly 6"s. Spose you could put some LED's there too - but not much point if you're doing footwells.

Think that'd look awesome shining through the covers.

For an easy-peasy install, I set some "under car" LEDs either side of the centre console, shining into the footwells - near the inner rear corner of front seats; this is easy install cos you can just run the wires under the console. The ones I used were self-stick as well - tho needed to reinforce that with contact glue after a while.

Others have recently put the LEDs at base of B-pillars, which may be a bit more "stealth", still shining into footwells.

I think some members have mounted lights along the front lower edge of seat cushion - near where the clips are which release the seat cushion - in that case I think the members used a "tube" style of light, either LEDs in a tube, or neons.

Nah dude, 6x9's are the ones basically above your boot, behind the rear seat, below your rear window..

The ones in the front doors are most commonly 6"s. Spose you could put some LED's there too - but not much point if you're doing footwells.

Think that'd look awesome shining through the covers.
Yeh I think I might do that hey thanks


For an easy-peasy install, I set some "under car" LEDs either side of the centre console, shining into the footwells - near the inner rear corner of front seats; this is easy install cos you can just run the wires under the console. The ones I used were self-stick as well - tho needed to reinforce that with contact glue after a while.

Others have recently put the LEDs at base of B-pillars, which may be a bit more "stealth", still shining into footwells.

I think some members have mounted lights along the front lower edge of seat cushion - near where the clips are which release the seat cushion - in that case I think the members used a "tube" style of light, either LEDs in a tube, or neons.

Yeh i thought bout under the cushion of the seat but wouldn be very safe n would get blocked by peoples legs and possibly damaged.


How bout a good place for the switches to turn them on and off from?