Obviosuly they are a BA9S fitting, and they can be no bigger than 11mm to fit through the parker hole.

What does everyone use for their parkers? And would they kindly share an ebay link :)?

Bumpity burrrrrmp

This thread recommends Philips 'Blue Vision' parker bulbs...
http://www.aussiemagna.com/forums/showthread.php?t=57256

That's what I went with and I can also recommend them. :D

Only in my case (as my front's been repaired so must have two different para headlights) the Parker bulbs only fitted one headlight (the other has a different fitting :nuts:). So now I have one nice white parker and one dull yellowish stock parker). Another thing added to the to-do-list. :doubt: But you can sure tell the difference between them!

Yeah my Highs and Lows are all sussed, It's just getting the right LED for the parkers...
Prefer LEDS over bulbs as i hate yellow light in headlights :P

you could try this.....

http://i184.photobucket.com/albums/x112/micpea/led%20para/roses.jpg


http://i184.photobucket.com/albums/x112/micpea/led%20para/rhled.jpg



heres what i used (http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=200373435475)

and LOOK HERE (http://s184.photobucket.com/albums/x112/micpea/led%20para/) to see how i did it,and the shots show ONLY the led globes,not the lights...whoot...double parkers...

Maggie 3.5 i love the work thats shown above and have lurked that thread for ages!

But what LED bulbs did you actually use for your normal parra fittings?

well,the low beam side has the std ba9s globe....and because i drilled out the high beam side,i needed a globe holder there,so i used a 2nd gen(see they are good for some thing)parker holder...and that uses a t10 wegde,so ,two lots of globes were used...i set of ba9s and a set of t10...hope this explains it...

of course i have two piece and whether or not the later one piece have the same globes...i dont know....they may have t10 as stock...