Ok so I am looking to find Poly bushes for the 380 stabiliser bar as the rubber ones are prone to fail so I emailed Heasman steering to see if they can get them but I need to know the size??


What size is the bar?

----- Original Message ----- From: <mechawombat@gmail.com>
To: <peter.vella@heasmans.com.au>
Sent: Monday, September 14, 2009 4:12 AM
Subject: Heasmans enquiry form

I am looking to get Stabiliser bar bushes in polyurethane. but no one has them for a 380 does your supplier have these bushes in poly??

Any one in the know??

Ok so I am looking to find Poly bushes for the 380 stabiliser bar as the rubber ones are prone to fail so I emailed Heasman steering to see if they can get them but I need to know the size??



Any one in the know??

Front bar is 23mm.

Thats not the strut bar size is it

But FOOZ you sir are awesome

I might have to take it in to let them have a gander

I am going to get the rubber ones replace tomorrow with OEM and take a worn one in for them to see and advise

FOOZ you sir are


AWESOME

I know ;)

I know ;)

Geez...

:roll:

Aww Fooz we are not worthy LMAO!!!
Let me know if you find any coilovers eh? I havent Checked with Tein yet but I doubt that they have any.

Thats not the strut bar size is it

But FOOZ you sir are awesome

I might have to take it in to let them have a gander

I am going to get the rubber ones replace tomorrow with OEM and take a worn one in for them to see and advise

No not the strut bar, it is definitely 23mm (the front sway bar). I measured both with digital verniers when I had it in pieces.

sweet awiting reply from Heasman

Just sussed out Nolathane to see if they had any bushes for the 380 at all.:cry::cry: Unfortunately they canned them before production as Mitsubishi Australia went south on the 380. Damn shame. Fulcrum do a limited amount of bushes for the 380, being front sway bar 23mm D bushes $28 a pair. They also do a kit for the lower control arm front and rear for $220 both sides. Option on this is you can get the rear bush with an eccentric hole to give you more castor if you are having problems with the car wandering. Best to get a it checked out firstly before doing this. You can get one side eccentric or both depending on the issue. Bursons deal in Fulcrum and Superpro products from memory. Hope this helps you out.

Well I ask my Mech to have a geezer and he test drove it and said that there was nothing

He did load the bushes up while it was on the hoist and it sorted the KNOCK out wierdly???

car handles so much better and saved me some dosh